How to replace the Hazard Warning Switch and Turn Signal Switch on Buick Park Avenue?

The replacement of the multifunction along with turn signal and hazard switch begins with disabling the sir system. You should start by taking off the Steering Column trim covers before uninstalling the multifunction switch retaining screws and disconnecting all electrical connections. Place the new switch on the Steering Column while tightening the retaining screws to 7 nm (62 inch lbs.). Install the new electrical harness before reattaching all electrical connections before putting back the Steering Column trim covers. Finally, enable the sir system.

OEM Buick Park Avenue Hazard Warning Switch

Hazard Warning Emergency Light Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Hazard Warning Switch found

View related parts
Buick Park Avenue Release Switch Part Number: 25630058
Product Specifications
- Other Name: Switch, Fuel Tank Filler; Fuel Door Release Switch; Switch; Switch, Rear Compartment Lid Release Or Ajar; Switch, Fuel Tank Filler Door
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1997-2005 Buick Park Avenue | Base, Ultra | 6 Cyl 3.8 L GAS

Buick Park Avenue Hazard Warning Switch

Our website offers an extensive catalog of genuine Buick Park Avenue Hazard Warning Switch at unbeatable prices. Every OEM Buick Park Avenue Hazard Warning Switch comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!

Buick Park Avenue Hazard Warning Switch Parts Questions & Experts Answers

Release Switch
25630058
Q: How to replace the Hazard Warning Switch and Turn Signal Switch on Buick Park Avenue?
A: The replacement of the multifunction along with turn signal and hazard switch begins with disabling the sir system. You should start by taking off the Steering Column trim covers before uninstalling the multifunction switch retaining screws and disconnecting all electrical connections. Place the new switch on the Steering Column while tightening the retaining screws to 7 nm (62 inch lbs.). Install the new electrical harness before reattaching all electrical connections before putting back the Steering Column trim covers. Finally, enable the sir system.