Choose OEM Door Moldings, you're making the optimal decision for superior quality and perfect performance. You can feel confident because each component goes through stringent quality checks. Every part is carefully built to comply with Saturn's factory specifications. You'll enjoy a smooth, worry-free installation that fits just right. At ChevyPartsGiant.com, you'll find it easy to get top-quality OEM Saturn Door Moldings. You can shop at highly competitive prices and protect your budget. All our genuine Saturn parts include a dependable manufacturer's warranty. You'll also appreciate our straightforward return policy and swift delivery services for extra convenience.
Saturn Door Moldings provide a Saturn driver with an additional protection against dashing in the parking lots and a clean beltline that compliments the dent resistant panels of the brand. Saturn was the product of General Motors, born in 1985 and was aimed at re-inventing the way cars are being constructed and sold. In 1991 the company had established its own manufacturing plant, had advertised a no haggle policy, and amazed consumers with flexible plastic body panels that were dents and corrosion resistant. It also employed lost foam casting within the engine block, which reduced weight without diminishing strength, also it launched a strong process of painting that preserved the colors bright many years. These imaginative touches created a loyal society, which continues glorifying the individual nature and extended life of any Saturn. The Door Moldings are a narrow casing at every door frame, preventing chips, wind whistle and water infiltration. To install smoothly, make sure the Door Moldings are of the right length and profile, dry fit, clean the surface, and make sure they are aligned with the crease line. In case the set uses adhesive tape, heat the strip and scratch the backside, start at the top, and roll with a soft roller all along the contour. Where applicable to the type of fasteners, locate the fastener at the factory hole, and then insert it and glue down the seam until the gaps are identified with the finger. Clean up fingerprints and allow the bond to dry and then wash the Door Moldings to match the rest of the panels and appear new.