GM 91176287
Bumper Cover

Both plastic retainers on each side of the rear bumper fascia need to be removed by accessing the wheelhousing area first. Raise the vehicle then find a suitable support position. Start by removing the screw attached to each rear bumper fascia side under the bottom and the two bolts located in the center of the bottom fascia. The vehicle needs to be lowered while you open either the endgate or rear door. Start by unclipping the 4 plastic retainers which fix the rear bumper fascia from the top edges before pulling it toward the back of the vehicle to extract it. You should attach the rear bumper fascia to the vehicle by inserting the 4 plastic retainers along its top edge. Begin by closing the endgate or rear door after which you can raise the vehicle. Two bolts should be installed at the center bottom of the rear bumper fascia followed by tightening these fasteners to 15 N.m(11 lb ft). After securing the screws on the bottom of each rear bumper fascia side down the vehicle must be lowered before installing the two plastic retainers which secure the wheelhousing area.

The first step in front Bumper fascia replacement requires removal of the headlamps together with the front side marker lamps. Seven plastic retainers situated along the top must be removed to detach the front Bumper fascia. Support the raised vehicle and disconnect the bolt and plastic retainer at the front Bumper fascia at each side then remove the three bottom bolts. Move the fascia frontward to take out the front Bumper from the automobile. Place the front Bumper fascia onto the vehicle while properly directing the front side marker lamps wiring harness before securing it with the 3 bolts along the bottom at 15 n.m (11 lb ft). Place and tighten the bolt along with the plastic retainer to 15 n.m (11 lb ft) at each side. Lower the vehicle while you fasten seven plastic retainers which go along the top. Propagate the front side marker lamps and headlamps before completion of the installation.

Raise and suitably support the vehicle.

Install the bolt and the plastic retainer on each side, also tightening the bolt to 15 Nm (11 lb ft).

Install the screw securing each side of the bottom of the rear bumper fascia, lower the vehicle, and finally install the 2 plastic retainers securing each side of the rear bumper fascia in the wheelhousing area.

Secure it with the 3 bolts along the bottom, tightening them to 15 N.m (11 lb ft).