GM 12335748
Bumper Cover

Starting the front Bumper fascia replacement requires the uninstalling of the grille followed by removing the 2 fasteners which connect the top of the fascia to the headlamp housing panel. Begin by supporting the vehicle raised level then push out the three fascia support rods holding the fascia onto its two support rods. Begin by separately detaching the fog lamps and cornering lamps and air deflector which are attached to the fascia. You must pull the fascia directly toward the front after freeing its body side tabs. To install position the fascia on the vehicle while ensuring the body side attachment tabs reach full seam then secure it to the 2 fascia support rods using 3 push-pins. Put back the air deflector followed by reinstallation of cornering lamps and fog lamps before lowering the vehicle to its normal position. Fx uses the upper central position of the fascia to secure the push-pin. Secure the top fascia to the headlamp housing panel using 2 bolts which should be tightened to 10 n.m (89 lb in). Finally, reinstall the grille.

The rear bumper fascia replacement process begins by taking away applicable back up lamp socket assemblies from back up lamp housings followed by removing the lower fascia push-pins and rear wheelhouse flange screws. The next step involves removing upper bolts from the fascias rear part before removing it from the vehicle. To install the fascia move it onto the vehicle impact bar after which install upper retaining bolts while tightening until reaching 2.5 N.m (22 lb in). Secure the fascia to wheelhouse flanges by applying screws until you reach 2 N.m torque (18 lb in). Insert the lower push pins completely after sealing the screws. The back up lamp socket assemblies must be reinstalled after completion of the repair process.