GM 12335575
Bumper Cover

The first step of front Bumper fascia replacement on a chevrolet requires removal of the front fender liner as well as the hood latch close out panel and headlamp assemblies. The next step involves disconnecting both fasteners that link the front fascia bracket to the front impact beam and additionally you should separate any electrical fog lamp connectors from your system. The fastener connecting the fascia to the fender may be accessed through the headlamp openings at the top of the vehicle before the fascia can be disconnected from its shoulder bolts by pulling it outward at the fenders and removing it from the vehicle. Set the new front Bumper fascia onto its installed position by applying it onto the fender shoulder bolts. Use the access point of the headlamp to install the fender-fascia attachment bolt before tightening it to 9 n.m (80 lb in). Fog lamp electrical connectors can be connected before adding fasteners to bracket-fascia connections on the Bumper beam then reinstalling headlamps and front fender liner components alongside the hood latch close out panel to finalize the installation procedure.

Tighten them to 3 N.m (27 lb in).

First, open the rear compartment.

Detach the fasteners that connect the front fascia bracket to the front impact beam and disconnect the fog lamp electrical connectors if equipped.