OEM 2000 Buick Park Avenue Turn Signal Switch

2000 Buick Park Avenue Parts Questions & Experts Answers

• Q: How to remove and install the Turn Signal Switch on 2000 Buick Park Avenue?

  A: Begin your work by disabling the sir system before handling the Turn Signal Switch. Take out the Steering Wheel then unlatch the tilt lever. Choose a lower shroud from each side and remove its torx(R) screws. Push the shroud down first and pull it back to separate locking tabs before removing a shroud protector. Take out the upper shroud from the vehicle by first removing its two torx(R) head screws. Disassemble the ip trim panel and remove the two torx(R) bolts from the multi-function switch followed by disconnecting all electrical connections to take out the switch. Begin by placing the multi-function switch over the tabs and fasten its two torx(R) bolts. Torque them to 7 nm (62 inch lbs.). Gently insert the electrical cables through the system and join their respective connections before putting in the ip trim panel. Torx bolt the upper shroud gently onto place while tightening them to 7 nm (62 inch lbs.). Push the lower shroud down and position its slits into matching tabs on the upper shroud. After that, raise the lower shroud edge and let its parts click together. Attach the two torx(R) bolts at 7 nm force and fasten the Steering Wheel to its mounting position. Finally, enable the sir system.