ChevyParts
My Garage
My Account
Cart
OEM Buick Park Avenue Turn Signal Switch
Turn Signal Indicator Switch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
5 Turn Signal Switches found
Buick Park Avenue Turn Signal Switch
Our website offers an extensive catalog of genuine Buick Park Avenue Turn Signal Switch at unbeatable prices. Every OEM Buick Park Avenue Turn Signal Switch comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Buick Park Avenue Turn Signal Switch Parts Questions & Experts Answers
- Q: How to replace the multifunction turn signal switch on Buick Park Avenue?A: Initially, disengage the SIR system in order to replace the turn signal switch. Disconnect the upper and lower trim covers and remember to make note of the connector from the abrasion sleeve on the steering column wire harness assembly for reassembly. Disconnect the turn signal and the turn signal switch assembly connector from the SIR system coil connector and detach the wire harness assembly away from the wire harness strap. Pull out the two connectors of the turn signal and turn signal switch assembly from the bulkhead connector. Use the two pan head tapping screws to take out the turn signal and turn signal switch assembly and take the assembly out from the steering column tilt head assembly. With installation, install the turn signal and turn signal switch assembly onto the steering column tilt-head assembly where the electrical contact should be seated on the turn signal cancel cam assembly. Secure the assembly with the two pan head tapping screws and tightening the top screw to 3 Nm (30 inch lbs.) and side screw to 7 Nm (62 inch lbs.). Screw the two connectors off the turn signal and turn signal switch assembly into the bulkhead connector and secure the assembly connector to SIR coil connector. Mount the abrasion sleeve back onto the steering column wire harness assembly, making sure the ignition lock cylinder case wire and connector are in the appropriate positions. Finally, place the wire harness assembly into the wire harness strap, reattach the upper and lower trim covers and enable the SIR system.
Related Buick Park Avenue Parts
Buick Park Avenue Body Control Module
Buick Park Avenue Back Up Light Switch
Buick Park Avenue Body Wiring Harness Connector
Buick Park Avenue Dome Light Connector
Buick Park Avenue Door Jamb Switch
Buick Park Avenue Engine Wiring Harness Connector
Buick Park Avenue Fog Light Connector
Buick Park Avenue Headlight Switch
Buick Park Avenue Ignition Switch
Buick Park Avenue Instrument Panel Harness Connector
Buick Park Avenue Neutral Safety Switch
Buick Park Avenue Speedometer