OEM 2002 Chevrolet Corvette Antenna Cable

2002 Chevrolet Corvette Antenna Cable Parts Questions & Experts Answers

• Q: How to replace the Antenna Cable in a convertible on 2002 Chevrolet Corvette?

  A: If you need to replace the Antenna Cable in a convertible, first open rear compartment lid and take out the rr end/corner carpet trim panel a number of the decklid latch carpet trim panel. Move the center carpet section to gain access to the front body wiring harness connectors then disconnect the same connectors from the decklid latch and the remote cd changer if available. Unclamp the right decklid support trim panel by pulling it free from retaining clips, next pull out the edge of the rear compartment floor carpet from the top of the right decklid support, then move the right side of this carpet after that. Unplug the power antenna coaxial cable from the power Antenna Cable and from the antenna electrical connector from the front Body Wiring Harness Connector. Release the front body wiring harness from retaining clip on rear compartment side wall, then close rear compartment lid. Lift up the top with the 1 and 5 bows both up and lift or leave up the folding top stowage compartment lid. Take out the push-in fastener and remove the rear compartment right side trim panel with the right lock pillar upper trim panel. Remove the front body wiring harness retainers from the back speaker housing and pull the front body wiring harness off the rear of the vehicle. Take off the right door sill plate and the right lock pillar lower trim panel and release the front body wiring harness retainers from the lock pillar and the floor panel support and the body retainers. Carefully pull off the tape that fasten the power Antenna Cable to the front body wiring harness, and then remove the ip right lower insulator panel to release the power Antenna Cable retainer from the ip lower support beam. Take out the radio control and the power Antenna Cable. For the installation, put the power Antenna Cable to the automotive and slot the radio control. Attach the power Antenna Cable retainer to the ip lower support beam and install the ip right lower insulator panel. Tape the power Antenna Cable to the front body wiring harness and then tape the front body wiring to the body retainers and finally secure the front body wiring retainers to the lock pillar and the floor panel support. Install the right lock pillar lower trim panel and the right door sill plate, place the front body wiring harness at the rear of the vehicle, and secure the front body wiring harness retainers to the rear speaker housing. Install the right lock pillar upper trim panel and the rear compartment right side trim panel and then insert push-in fastener. Lower the folding top stowage compartment lid, raise convertible top and open rear compartment lid. Secure the front body-wiring harness to the retaining clip in the rear compartment side wall, connect the antenna electrical connector to front Body Wiring Harness Connector, connection power Antenna Cable to the power Antenna Cable. Install the edge of the rear compartment floor carpet a ways behind the right decklid support, then install the right decklid support trim pan aligning it and pushing to silence the retaining clips. Connect the front body wiring harness connectors to the decklid latch and while the remote cd changer equipped install the center carpet section, the decklid latch carpet trim panel, the rr end/corner carpet trim panel and the final step close the rear compartment lid.