OEM 2006 Chevrolet Aveo Wheel Bearing

2006 Chevrolet Aveo Parts Questions & Experts Answers

• Q: How to replace the rear wheel bearing and hub on 2006 Chevrolet Aveo?

  A: Start the rear Wheel Bearing and hub replacement process with the following tools: j 23444-a extreme press lubricant, ch-47914 bearing replacer, and both ch-47914-2 (large) and ch-47914-3 (small) spacers. The required supplies include j 23444-a extreme press lubricant with ch-47914 bearing replacer alongside ch-47914-2 (large) and ch-47914-3 (small) spacers. First remove the Wheel Bearing retainer clip before inserting the threaded rod through the bearing while making sure the raised section of spacers fits within the inner bearing race. Fit the ch-47914-2 and ch-47914-3 spacers onto the rod after placing two flat washers (2, 5) and two nuts (4, 7). Drill two nuts to fix the spacers onto the bearing while making certain the rod extends beyond the bearing's outboard side. Spread a light layer of j 23444-a onto the rod before placing the thrust bearing between the receiver and flat washer that rests on the rod. Position first the flat washer and then the nut onto the rod before tightening the nut to extract the bearing both from the Brake Drum and from the ch-47914 component. When installing the rear Wheel Bearing with the ch-47914 apply the spacing components into the bearing race so their raised surfaces face inside. After putting ch-47914-2 and ch-47914-3 in place you should secure them by adding two flat washers (5, 7) and two nuts (1, 4) to the rod then tightening the nuts. Affix the large rod spacer to the outboard position of the rear Brake Drum prior to insertion while the rod receives a light coating of j 23444-a. Place the thrust bearing so it sits between the receiver and flat washer on the rod before adding both the flat washer and the nut. Because power tools can cause damage to the Wheel Bearing it must be properly installed into the drum before tightening the nut which will force the Wheel Bearing into its seat. Complete the procedure by taking off the ch-47914 component while installing the Wheel Bearing retainer clip.