GM 95492092
Front Hub

To replace the wheel hub, bearing, knuckle and seal then first remove the drive axle from the front wheel hub, after then the inner snap ring. To remove the hub of the wheel, use the j 37105-1 support bridge, j 37105-3 hub adapter, 500-20 hex nut, j 37105-2 bearing adapter. Then, remove the disc brake splash as well as the outer snap ring. The wheel bearing may then be removed using the j 37105-1, j 37105-2, 500-20 and j 36661-2 forcing screw. Clean the bore of the knuckle where it's going to be assembled. Mount the outer snap ring and push the wheel bearing into place with j 37105-1, j 37105-2, 500-20, and j 36661-2. Then install the disc brake splash, put in the inner snap ring, push the wheel hub in its place with the help of j 37105-3, j 37105-2, 500-20 and j 36661-2. Lastly, reinstall the drive axle back to the front wheel hub.

Apply a light coat of J 23444-A on the rod.

Begin by removing the drive axle from the front wheel hub, followed by the inner snap ring.

Carefully pull the wheel bearing and hub assembly straight off the spindle, as the 2 inner wheel bearing races may not be secure.

Ensure the hub rotates smoothly.

Install the outer snap ring and push the wheel bearing into place with the J 37105-1, J 37105-2, 500-20, and J 36661-2.

Remove the rear wheel speed sensor if equipped, followed by the brake drum.

Stake the caulking nut.

Lower the vehicle.

Reattach the retaining ring and then the brake shield.

First, raise and support the vehicle.