OEM 2006 Chevrolet HHR Intake Manifold

2006 Chevrolet HHR Intake Manifold Parts Questions & Experts Answers

• Q: How to replace the intake manifold on 2006 Chevrolet HHR?

  A: To remove the Intake Manifold, first, remove the air cleaner assembly followed by disconnecting the throttle actuator control (TAC) electrical connector and the fuel injector electrical connector. While for those with a manual transaxle the engine harness clips (2 and 4) need to be disconnected from the Intake Manifold, with those that have an automatic transaxle, commute in the same action. Unplug the engine harness clip from the level indicator oil tube then the fuel injector electrical clip from the Intake Manifold. Then, disconnect the engine harness clip from the oil level indicator tube and the fuel injector electrical connector clip from the Intake Manifold. After this, take out the Throttle Body bolts and ensure that the Throttle Body seal is reusable is subject to damage, and remove the Throttle Body as well as the seal, observing the Throttle Body seal. Remove the oil level indicator tube and the Fuel Rail then disconnect the purge evap purge tube from Intake Manifold as well as the evap solenoid. Take off the Intake Manifold lower bolts and the upper bolt and nuts and pull off the Intake Manifold and look at the Intake Manifold Gasket for damage and replace with a new one if needed. For installation, if there is need of a new Intake Manifold Gasket install it,; otherwise, reuse the old gasket. Install the Intake Manifold, followed by the upper bolt and nuts and then the lower bolts with 10 nm(89 inch lbs). Remove the Fuel Rail and oil level indicator tube, and reconnect the eal canister purge tube to the Intake Manifold and the evap solenoid with a new Throttle Body, seal if required, before installing the Throttle Body and using bolts tightened to 10 nm (89 inch lbs.). For automatic transaxles, join the engine harness clip (2 and 4) to the Intake Manifold, then join the engine harness clip to the oil level indicator tube and the fuel injector electrical connector clip to the Intake Manifold. For manual transaxles, connect the engine harness clips, 2 and 4, on to the Intake Manifold, then the next engine harness clip onto oil level indicator tube then the fuel injector electrical connector onto the Intake Manifold, clip . Kraftrecords.this is how to power-slide your isc to start your 2004 tacoma. Lastly, connect the fuel injector electrical connector and the throttle actuator control (TAC) electrical connector, and reinstall the air cleaner assembly.