OEM 2009 GMC Acadia Tie Rod

2009 GMC Acadia Tie Rod Parts Questions & Experts Answers

• Q: How to replace the steering linkage outer tie rod on 2009 GMC Acadia?

  A: You must remove the front wheel followed by the tire before starting to replace the steering linkage outer Tie Rod. Separate the steering linkage outer Tie Rod by removing its nuts then begin loosening the inner Tie Rod nut. The j 24319-b (Steering Linkage and Tie Rod Puller) for buick, gmc, and chevrolet instead of the sa91100c (Tie Rod Separator) for saturn should be used to separate the steering linkage outer Tie Rod from the Steering Knuckle because pickle forks and wedge type tools should be avoided to protect the ball stud from damage and the seal and bushing system. Measure the full turning motions until the steering linkage outer Tie Rod pulls free from the steering linkage inner Tie Rod. Socialize the outer Tie Rod part from its attachment with the inner part of the steering linkage. The installation process requires connecting the steering linkage outer Tie Rod to the steering linkage inner Tie Rod but avoid tightening the inner rod nut at this stage. Rotating the steering linkage outer Tie Rod to the Steering Knuckle requires fastener maintenance with clean surfaces and rust-free elements. After the fastener reaches 2 nm (18 lb in) torque level it can seat properly; otherwise you should replace the fastener. When installing the steering linkage outer Tie Rod nut make sure to tighten it to 30 nm (22 lb ft) while adding 120 degrees flat (2 flats). Maintain 2.5-4.5 threads of the outer Tie Rod End exposed from the nylon piece on both sides. The front wheel reassembly requires a 75 nm (55 lb ft) torque setting on the steering linkage inner Tie Rod nut. Finally, adjust the front toe.