OEM 2010 Chevrolet Camaro Window Regulator

2010 Chevrolet Camaro Parts Questions & Experts Answers

• Q: How to replace the front side door window regulator on 2010 Chevrolet Camaro?

  A: The replacement process of the front side door Window Regulator starts with trims panel removal followed by water deflector stripping. After separating the door window switch from the door trim panel you should connect it to the door harness to operate the window. Mark the edge of the outer reveal belt seal as well as the mirror patch followed by creating three marks on the window glass for proper starting placement. Seamlessly take out the front side door window by writing down all bolt and nut positions for accurate reinstallation. Melt off the front side door Window Regulator cable retainers and nut covers followed by removing the lower nuts and upper nuts and Window Regulator motor bolt before disconnecting the electrical from the motor and taking out the Window Regulator. Install the Window Regulator motor on the new regulator while tightening the rear rail lower nut followed by the front rail lower nut then align the bolts according to the marks made beforehand. Use 10 nm torque when securing the upper nuts and lower nuts and motor bolt. Write the electrical cable and its connectors to the motor before reinstalling the cable retainers with their nut covers. Secure the front side door window by using the marks made previously and tighten the regulator clamps to the window. Proceed with door closure after adjusting the settings and using the outside handle to unlock the door latch. The inspection confirms proper functionality of the window. Then reinstall the water deflector accompanied by the window switch and front side door trim panel. Finally, clean the door window.