OEM 2010 Chevrolet Corvette ABS Control Module

2010 Chevrolet Corvette Parts Questions & Experts Answers

• Q: How to replace the ABS Control Module on 2010 Chevrolet Corvette?

  A: The first step for ABS Control Module replacement is to turn the ignition switch to off position while disconnecting the negative Battery Cable (LS3 or LS7 or LS9). After vehicle lift and support you should remove dirt from surrounding areas of ABS Control Module and brake pressure modulator valve (BPMV). First disconnect the ABS Control Module electrical connector then remove the ABS Control Module bolts. Widen the ABS Control Module unit slowly out from bpmv by applying minimum force that avoids damaging fitted parts. Scrub the sealing areas of the ABS Control Module and bpmv with a solution of denatured alcohol followed by a drying period. The ABS Control Module installation requires users to align the ABS Control Module component directly onto the bpmv but avoid excessive force on the installation. The ABS Control Module bolts must be installed across the board before tightening them to 3 nm (27 lb in). After replugging all ABS Control Module electrical wires users must put the negative Battery Cable back (LS3 or LS7 or LS9). The service programming system (SPS) needs to be used for programming a new ABS Control Module. The diagnostic system check - vehicle should be performed as the last step of installation.