Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2016-2017 GMC Acadia | Denali, SL, SLE, SLT | 4 Cyl 2.5 L GAS, 6 Cyl 3.6 L GAS
GMC Acadia TPMS Sensor
Our website offers an extensive catalog of genuine GMC Acadia TPMS Sensor at unbeatable prices. Every OEM GMC Acadia TPMS Sensor comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
GMC Acadia TPMS Sensor Parts Questions & Experts Answers
A: Set the sensor's cap and valve on a clean area while verifying the aluminum cap with nickel-plated valve to stop corrosion. When replacing parts always use the correct part number with the specified torque value to prevent damage. Put the bead breaking fixture at a right angle to the valve stem before inserting the tire iron or pry bar slightly ahead of the sensor body while lifting the tire bead over the mounting/dismounting head. The tire machine should rotate tire/wheel assemblies clockwise to position the tire bead correctly on the outer wheel rim before removing the tire from the wheel. Tires containing sealant will require a complete removal of all remaining liquid residues from wheel and tire surfaces. The sensor nut and the sensor must be detached from the installation. Insert the sensor into the wheel hole with the air passage aimed toward the outside of the wheel while clearing any debris from the grommet sealing zone. Service replacement tire pressure sensors come off before installation in OFF mode requiring that the tire/wheel assembly reaches speeds above 32 km/h (20 mph) continuously for 10 seconds to activate the switch inside the sensor. Torque the sensor nut to 7 N.m (62 lb in) with the sensor body facing parallel to the inside wheel surface. Place the mounting tool at a 180-degree angle to the valve stem when installing the tire and orient the tire beads 45-degrees counterclockwise from the valve stem direction. Use a clockwise rotation of the tire/wheel assembly to push the tire bead inside the wheel rim then repeat this procedure for the outer bead before tire installation. The service replacement tire pressure sensor arrives in OFF mode requiring at least 10 seconds of tire/wheel assembly rotation above 32 km/h (20 mph) to activate the sensor's internal roll switch for closure. After installing the tire/wheel assembly onto the vehicle and letting it lower down learn the pressure sensors.