GM 15232236
Slave Cylinder

In order to remove the Clutch Master Cylinder, you have first to disconnect the push rod from the clutch pedal before removing it. With the right tool on hand (Fluid Extractor), extract the fluid from the reservoir and extract the reservoir off the mounting bracket. Next, take out the line clip at the master cylinder and disconnect the line from the master cylinder to the clutch concentric actuator cylinder. Following that, remove the master cylinder mounting nuts and the master cylinder assembly. For installation, place the master cylinder assembly on the bulkhead and fit the mounting nuts with a tightening of 36 nm (27 ft. Lbs.). Refasten the reservoir to the mounting bracket and realign the master cylinder's electrical harness. Join the line from the clutch concentric actuator to master cylinder and install the line clip, the line from the master to the clutch concentric actuator cylinder. Finally, actuate the Pushrod from the brake pedal to the master cylinder, fuel the master cylinder fully (check Fluid and Lubricant Recommendations), and bleed the hydraulic system.

In order to remove the Clutch Master Cylinder, one requires to detach the push rod from the pedal of the clutch, use the appropriate tool to drain the fluid from the reservoir, and unmount the reservoir from the bracket. Next, take the line clip off from the master cylinder and the line attached to the master cylinder and clutch concentric actuator cylinder. Then, unscrew the master cylinder's mounting nuts and pull out the master cylinder assembly. For mounting, install the master cylinder assembly onto the bulkhead and fit the mounting nuts, tightening to 36 nm (27 ft. Lbs.). Put the reservoir back in place on the mounting bracket, resituate the electrical harness to the master cylinder, and hook the line from the clutch concentrator actuator to the master cylinder. Secure the line clip to the line starting from the master cylinder to the clutch concentric actuator cylinder, then the Pushrod that acts on the brake pedal to the master cylinder. Finally make sure to fill the master cylinder with fluid and bleed the hydraulic system.