GM 15888058
Headlamp Assembly, Driver Side

You can replace the headlamp and bulb components including cornering and turn signal lights by taking these steps. Place tape over the headlamp retaining clip but the radiator grille straps to prevent them from scratching the lens during the removai Pull the bottom outboard headlamp area gently to unhook the lower rear headlamp mount before removing the mounting bolts at position 1 and 2. Take out the headlamp by first removing its four bulbs at the rear and disconnecting it from its vehicle location. Use the headlamp opening space to set the headlamp and place bulbs (2, 3, 4, 5) into the headlamp. Mount the headlamp while pushing until you see the rear lower retainer engage and place bolts (1,2) by securing them at 2.5 N.m (22 lb in). Set the fascia in place and connect the radiator grille strap into headlamp before attaching it to its tie bar push-in retainers. Finally, close the hood.

Remove the bulbs from the backside of the headlamp and take the headlamp out of the vehicle.