GM 20800302
Upper Console, Olive

Start with removing the battery ground cable before console replacement. Start by removing the shifter knob followed by opening the console door while you unhook the console bin's hinge cover from the rear retainer. Begin by taking off the console Cup Holder and ashtray then continue with the console trim plate removal. The front console mounted to the instrument panel carrier needs removal through unplugging these components: console nuts and bolted attachment points. To disconnect the front from under the i/p carrier raise the space at the console's rear and pull it towards the back. Disconnect the electrical connector connected to the electrical accessory plug then remove the console electrical accessory plug retainer and housing before proceeding with removal. Use the end of a flat tool to pull the lamp loose from its retainer before guiding it through the console bin opening before removing the console from the vehicle. Position the console in its vehicle space then install the console lamp by passing it through the hole in the bin before pushing it to secure the retainer. The console receives its electrical accessory plug housing by engaging the housing to its designated spot while maintaining the cover plug in position and securing the electrical accessory plug retainer onto the housing. Follow these steps when connecting the electrical connector to the accessory plug while positioning the console front end under the i/p carrier's rear portion. Fasten the console with retaining hardware and use tools to tighten the nuts to 10 n.m (89 lb in). After the reinstallation of console trim plate and Cup Holder, return the ashtray and fasten the console bin hinge cover by pressing down to activate its retaining clips. When finished, close the console door and check for proper fit and then reinstall the shifter knob. Reconnect the battery ground cable as the last step.