To replace the front floor console for full-length manual transmission, first; remove the shift control lever, Cup Holder, and the screws which fasten the trim plate to the console and take off the trim plate. Open the cover of the storage compartment and take out the storage compartment. The next step is using the nuts that secure the console on the vehicle to get them off, disconnect the electrical connector if you have one, to lift the console off its position. For installation, set the console back into the vehicle and plug the electrical connector if available. Tighten the nuts to fix the console to 10 n.m (88 lb in), and after that, the storage compartment. Reconnect the trim plate to the console and supporting it in with screws, while tightening each of them to 1.9 n.m (17 lb in). Last, replace the Cup Holder insert and the shift control lever.