Q: How to replace the front side inner door handle on Chevrolet Colorado?
A: The procedure starts with removing the front door trim panel alongside the water deflector before changing the front side door inside handle. The next step requires you to slide the inside door handle rearward to free the retaining tabs from the door inner panel before you remove lock cables from the inside door handle and extract the handle from the door. During installation the lock cables need to be connected to the inside door handle before the retaining tabs are inserted into the slots of the door inner panel until the handle reaches full engagement. Terminate the procedure by replacing the front door trim panel and the water deflector.
Q: How to replace the front door exterior door handle on Chevrolet Tahoe?
A: One should start the front door exterior handle replacement journey by removing the trim panel and water deflector. First detach the outside handle rod from the rod clip followed by removing the lock cylinder rod from its clip. You should first free the outboard nut by removing the outside handle mounting nuts and the rubber cover. Separate the door-lock cylinder from the outside handle housing before resolving any restrictive lock cylinder function. Set and install the new handle onto the vehicle after handle removal. The inside of lock case together with the cylinder keyway requires lubricant gm p/n 12345120, canadian p/n 726548 or equivalent before reinstalling the lock cylinder. The outside handle housing receives the door-lock cylinder followed by the clipping of the lock cylinder clip onto the rod. Grab the handle rod and join it with the handle assembly clip before tightening the outside handle mounting nuts to 9 n.m (80 lb in). After completion, you must reinstall the rubber cover together with the water deflector along with the trim panel.
Q: How to replace the front inside door handle on Chevrolet S10?
A: Beginning the front inside door handle replacement requires step one to remove the door trim panel alongside removal of inside door handle rods and retention rivets. A backward motion on the inside door handle will allow you to break its connection to the door structure. Start by inserting the new inside door handle forward where it should fit properly before adding the retaining rivets which must be followed by installing the inside door handle rods. You should place the door trim panel back into position at the end.