Suburban 1500 | 2007-2014 | LS, LT, LTZ | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
Suburban 2500 | 2007-2013 | LS, LT, LTZ | 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS
Tahoe | 2007-2014 | Hybrid, LS, LT, LTZ | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
Equinox | 2010-2017 | L, LS, LT, LTZ, Premier | 4 Cyl 2.4 L FLEX, 4 Cyl 2.4 L GAS, 6 Cyl 3.0 L FLEX, 6 Cyl 3.0 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
Q: How to replace the rear wiper blade on Chevrolet Malibu?
A: Begin by moving the rear Wiper Arm to its service up spot and then take the Wiper Blade off the Wiper Arm. After that, place the new Wiper Blade onto the arm and push it securely in place. Make sure to run the rear wipers and confirm they are working as they should.
Q: How to Replace a Wiper Blade Element on Chevrolet Camaro?
A: You first need to take off the Wiper Blade from its holder to replace the blade component. Take off the Wiper Blade bottom claws from the Wiper Blade element notches before pulling it out from the claws. Install the Wiper Blade claws in the rubber slots of the Wiper Blade element while keeping them away from the metal spline. First push the wide end of the Wiper Blade element into the bottom claws of the Wiper Blade and feed the Wiper Blade element through all the claw sets. Insert the bottom claw of the Wiper Blade into notches of the Wiper Blade element before fixing it to the Wiper Arm.
Q: How to Replace the Rear Wiper Blade on Chevrolet S10?
A: You must first lift the Wiper Arm away from the window to replace its rear blade making sure it does not hit the windshield by accident. Depress the locking tab on the Wiper Blade clip then pull down to disconnect it. Take out the Wiper Blade pivot from the inner area of the arm and move the Wiper Arm out through the Wiper Blade gap. To set up the Wiper Blade insert it through the slot in the Wiper Blade then fit the blade inside the hook's center before pulling up until the mounting tab clicks in its slot. Slowly place the Wiper Arm and blade onto the window section.