Other Name: Striker, Rear Compartment Lid Lock Or Liftgate; Striker, Rear Compartment Lid
Fits the following Chevrolet Models:
Equinox | 2010-2017 | L, LS, LT, LTZ, Premier | 4 Cyl 2.4 L FLEX, 4 Cyl 2.4 L GAS, 6 Cyl 3.0 L FLEX, 6 Cyl 3.0 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
Other Name: Striker Assembly-Rear Compartment Lid Latch
Position: Rear
Replaces: 10295278, 10442729
Fits the following Chevrolet Models:
Impala | 2000 | Base, LS | 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
Monte Carlo | 2000-2004 | LS, LS Competition, LS Sport, SS, SS 35th Anniversary Edition, SS Dale Earnhardt Signature Edition, SS High Sport, SS Pace Car | 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
Q: How to replace the lower rear side door striker on Chevrolet Colorado?
A: You should open the rear side access door before removing the bolts which hold down the lower side door striker to the body structure. After extracting the striker itself. Install the new lower side access door striker onto the body by following fastener precautions to protect against vehicle damage. Add the bolts to secure the striker while tightening them to 25 Nm (18 lb ft). Close the rear side access door as the last step.
Q: How to replace the upper front door striker on Chevrolet S10?
A: The first step to replace the upper front door striker requires you to remove the rear side door upper latch striker cover using a flat-bladed tool to release retainers from the roof panel. Secondly you need to extract the bolts which bind the striker to the roof panel before removing the striker together with its attached shims from the panel. When installing the striker you need to return it to the roof panel together with the shim(s) while adhering to the Fastener Notice guidance mentioned in Service Precautions. Secure bolts to the roof panel mounting of the striker before adjusting its position by tightening down the bolts until it reaches a proper fit while self-aligning the striker and performing door fit checks. The number of shims can be adjusted up to 3 items before you tighten the striker bolts to 10 N.m (89 lb in). Finish this operation by adding the upper door latch striker cover.
Q: How to replace the lower front door striker on Chevrolet Tahoe?
A: The replacement process for a lower front door striker starts by opening the side access door followed by removing the lower door striker retaining bolts. Remove the lower door striker that exists inside the vehicle through the following steps. You must attach the lower door striker to the vehicle according to the Fastener Notice in Service Precautions before you can install the retaining bolts. The lower door striker retaining bolts must be tightened to 20 N.m (15 lb ft).