Q: How to replace the front side door car speakers on Chevrolet Colorado?
A: You should begin the front side door speaker replacement by removing the front door trim panel. First remove the door-mounted screw before gently remove the speaker with its attached tabs from the slots in the door structure. Disconnect the speaker electrical connector. The first step for installation involves connecting the speaker electrical connection after you position the two tabs of the speaker into its door mounting slots. Proceed with care when tightening fasteners to prevent vehicle injuries. Use the screw to mount the speaker onto the door before tightening it to 2.5 nm (22 lb in). The front door trim panel must be replaced at the end of installation.
Q: How to remove and install the rear car speakers on Chevrolet S10?
A: The removal of the rear speaker starts by removing the rear body side trim panel followed by disconnecting the electrical connectors. After disconnecting electrical connectors you should remove radio rear speaker nuts from the trim panel before taking out the rear speaker. The installation process requires a step-by-step approach starting with attaching the radio rear speaker onto the rear body side trim panel according to the Fastener Notice in Service Precautions. Screw the radio rear speaker nuts at 1.2 N.m (11 lb in) torque using a torque wrench because after you complete the reconnection of electrical connectors you will reinstall the rear body side trim panel. Conclude the inspection by checking circuit functionality.
Q: How to replace the front door car speakers on Chevrolet Tahoe?
A: You should start by taking off the front door speaker trim panel to perform replacements. The removal of the speaker begins with gently pressing down the top retainer. Once the speaker is loose, disconnect its electrical connector. Install the speaker by first plugging in the electrical connector then place the speaker into position until it entirely seats into its socket. Reinstall the trim panel before checking whether the new component operates correctly.