Tahoe | 2007-2014 | Hybrid, LS, LT, LTZ | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
Equinox | 2010-2017 | L, LS, LT, LTZ, Premier | 4 Cyl 2.4 L FLEX, 4 Cyl 2.4 L GAS, 6 Cyl 3.0 L FLEX, 6 Cyl 3.0 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
Q: How to replace the Weather Strip on the rear side access door on Chevrolet Colorado?
A: Replacements of the rear side access door's weather strip begin following the procurement of Door Trim Pad Clip Remover (J 38778) as necessary tool. The first step involves opening both side access doors at the front and the rear. The removal of upper molded detail from front side access door starts when you place Door Trim Pad Clip Remover (J 38778) beneath weather strip mold to free the three integral retaining pins. The same Door Trim Pad Clip Remover (J 38778) tool will be used to extract the sole retaining pin of the lower front molded detail from the side access door. Use the Door Trim Pad Clip Remover (J 38778) to move integral pins from the door by placing it under the weather strip. The installation involves placing the new weather strip on the rear side access door after you remove the weather strip from the side access door. The upper and lower molded details must first be attached to the front of the rear side access door through the integral retaining pin before applying the lower molded detail to its position with a second integral retaining pin. Close the front and rear side access doors after installing the weather strip onto the rear door frame through its integral retainers.
Q: How to replace the Weather Strip for the sunroof/moonroof on Chevrolet S10?
A: You should begin the sunroof/moonroof weather strip replacement process by removing the roof drip weather strip from the door opening frame while also eliminating all remaining weather strip material and adhesive. The following step involves removing the adhesive from the natural rubber weather strip. The weather strip seal should be placed at the upper rear door opening corner against the body side outer panel before you install the strip forward across the roof flange and down the windshield revel molding flange.
Q: How to replace the rear door Weather Strip on Chevrolet Tahoe?
A: First, open the door so you can take off the Weather Strip from where it's attached. During installation of the new Weather Strip, make sure your work surface has no dust or dirt, as these can stop the adhesive from sticking well. Removing the backing paper first, press the retainers in position and close the door after.