Q: How to replace the front side door window regulator on Chevrolet Colorado?
A: Commence replacement of the front side door Window Regulator by taking out the front door trim panel along with the front door water deflector first. Next you must detach the bolts holding the front door window to its regulator before removing the front door window. You must disconnect the electrical connector from the Window Regulator motor when the vehicle has a31 as its equipment. Loosen the bolts securing the Window Regulator at its keyhole slots then pull out all remaining fasteners keeping it within the inner panel. The Window Regulator can be lifted out of its keyhole slots before being extracted through the access hole. To install the front door Window Regulator pass it into the access hole before guiding the regulator bolts through the inner panel keyhole slots to position it correctly. Screw the fastener that will retain the front door Window Regulator to the door and torque the fasteners to 9 n.m (80 lb in). Install a31 at the same time by linking the electrical connector to the Window Regulator motor. Reinstall the front door window through its bolt slots and secure it by tightening those bolts to 9 n.m (80 lb in). Secure the system by putting back the front door water deflector followed by the front door trim panel.
Q: How to replace the rear door window regulator on Chevrolet Malibu?
A: The replacement of the rear door window regulator requires you to remove both rear door trim panel and rear door water deflector first. A sufficient window raise will allow access to the window peg retainer where you should detach the nylon peg that connects the rear door window to the regulator. Safety tape crosses the window opening from top to bottom while the window stands in full elevation. Disconnect the electrical connector before removing the regulator motor bolts through which you can lift the motor to remove the retaining bolts. The next step involves removing bolts from the rear door window regulator before removing it completely from the door. Place both rear door window regulator and motor into the door frame according to the Fastener Notice in Service Precautions. Mount the regulator bolts before torquing them to 10 N.m (89 lb in) while observing the Fastener Notice in Service Precautions. Reestablish the electrical connection followed by tape removal from the window then decrease the window opening to enable door window insertion. The two bolts holding the rear door window regulator should be installed before you tighten them to 10 N.m (89 lb in). The last step includes reinstalling both the rear door water deflector and the rear door trim panel.
Q: How to replace the front door window regulator on Chevrolet Tahoe?
A: Slide-out the front door Window Regulator to be replaced. First, raise and support the front door window to be replaced; then remove the trim panel and the water deflector. Disconnect the wiring harness from the Window Motor assembly and then remove the 2 bolts that hold the window to the regulator as well as removing the bolts from the Window Regulator itself. Gently remove the Window Regulator assembly from the door by folding both sides. For installation, affix the regulator to the door, taking care to observe the fastener notice in service precautions. Attach the bolts to the Window Regulator and torque this to 9 n.m (80 lb in). Position the window relative to the regulator and mount it using the bolts and tighten them at 9 n.m (80 lb in). Reconnect the wiring harness to the Window Motor assembly, reconnect the water deflector, and the trim panel. Finally, open the window, lowering it and observing its functions.