Other Name: Latch Assembly-Rear Side Door Lower (Left-Hand); Door Lock Actuator Motor; Door Latch Assembly; Door Lock; Lower Latch; Lock; Latch, Rear Side Door
Position: Rear Lower Driver Side
Replaces: 52031130
Fits the following Chevrolet Models:
Colorado | 2015-2022 | Base, LT, WT, Z71, ZR2 | 4 Cyl 2.5 L GAS, 4 Cyl 2.8 L DIESEL, 6 Cyl 3.6 L GAS
Other Name: Lock, Rear Compartment Lid Or Tail Gate Latch; Trunk Latch; Door Lock; Latch; Latch, Rear Compartment Lid Or Tail Gate Latch; Latch, Rear Compartment Lid Release Or Ajar
Q: How to replace the rear door lock on Chevrolet Prizm?
A: The replacement of the rear door lock begins with removing the rear side door trim until access becomes available. Use a thumb to pull out the water deflector to reach the door lock mounting bolt. Detach the power door lock actuator electrical connector only if your vehicle is equipped with this feature followed by removing the door locking rod from the door lock knob linkage. Remove the inside handle rod along with the door locking rod by disengaging them from the door. Use a door lock rod protector to carefully release it from the door before removing the door lock and rods (3, 4) by uninstalling their 3 screws and bolt. The door lock receives the inside handle rod for installation when needed. The rear door lock should be installed onto the door while using 3 screws and the bolt to secure it by applying a tightening torque of 5 N.m (43 lb in). The door lock rod protector together with the inside handle rod and door locking rod should be installed into their respective door retainers. Complete the power door lock electrical connection if present and place the water deflector correctly before installing the rear side door trim.
Q: How to replace the rear sliding door lock on Chevrolet Venture?
A: Starting the replacement process of the sliding door rear lock requires removal of the sliding door inner trim panel and the sliding door water deflector. Start by removing the sliding door latch screws followed by hooking out the lock rod from the sliding door rear lock after it becomes loose. Then extract the rear lock from the sliding door. Place the sliding door rear lock onto position on the sliding door while hooking the lock rod into its place. Tighten the sliding door rear lock screws to 10 N.m (89 lb in) following the provided sequence of fastener tightening. The final step includes reinstalling the sliding door water deflector after you reinstall the sliding door inner trim panel.