Q: How to replace the power seat switch on Chevrolet Camaro?
A: The power seat switch replacement process starts with the removal of the front bucket seat and subsequent stripping of the recliner trim cover attached to it. First disconnect the wire harness from the power seat switch after which you should remove the screws that hold the power seat switch to the recliner trim cover to extract the switch. Install the power seat switch to recliner trim cover by securing it with screws which require torque adjustment to 1.7 N.m (15 lb in). Secure the wires of the power seat switch to its connector before placing the recliner trim cover back onto the bucket seat and screw it into place using torques at 1.7 N.m (15 lb in). The last step of the project involves replacing the bucket seat.
Q: How to perform a Seat Switch replacement for the lumbar on Chevrolet Colorado?
A: The first step to replace the lumbar switch requires elimination of the seat cushion outer trim panel. Before starting the replacement process, remove the switch bezel from the seat assembly followed by removing the buttons from the switch. The release of tabs holding the seat switch to the seat bezel reveals the disconnect of the lumbar switch harness from the seat harness. You should now remove the lumbar switch from its position inside the seat bezel. Installation requires users to first link the lumbar switch harness with the seat harness before placing the lumbar switch properly into the seat bezel while verifying that all retaining tabs are secure. After attaching the buttons to the switch install it with the bezel assembly onto the seat assembly. Last step involves the reinstallation of the seat cushion outer trim panel.
Q: How to perform a Seat Switch replacement for the Driver Seat Adjuster Memory on Chevrolet Malibu?
A: The first step to install a new driver seat adjuster memory switch involves lifting up the front edge of the Door Lock and side window switch until the front retaining clip releases. After that, use the same method to remove the two rear retaining clips securing the switch panel. Detach the electrical connector from the memory Seat Switch and directly extract the memory Seat Switch from the lock and Door Lock and side window switch assembly. To install the components begin by placing the memory Seat Switch onto the lock and Door Lock and side window switch position then apply the electrical connector to the memory Seat Switch before installing the Door Lock and side window switch while verifying that both front and rear retaining clips have complete seating positions.