Other Name: Strut, Lift Gate; Liftgate Lift Support; Door Lift Support; Lift Support; Support Strut; Strut, Rear Compartment Lid Or Tail Gate Counter Balance
Position: Passenger Side
Replaced by: 42841645
Fits the following Chevrolet Models:
Bolt EV | 2017-2021 | LT, Premier | BATTERY EV (EV/BEV)
Other Name: Strut, Rear Compartment Lid Or Tail Gate Counter Balance; Trunk Lid Lift Support; Lift Support; Strut
Position: Rear
Replaces: 10425344
Fits the following Chevrolet Models:
Impala | 2000-2005 | Base, LS, LS Sport, SS | 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
Monte Carlo | 2000-2007 | LS, LS Competition, LS Sport, LT, LTZ, SS, SS 35th Anniversary Edition, SS Dale Earnhardt Signature Edition, SS High Sport, SS Pace Car | 6 Cyl 3.4 L GAS, 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 3.9 L GAS, 8 Cyl 5.3 L GAS
Other Name: Strut, Lift Gate; Back Glass Lift Support; Liftgate Lift Support; Tailgate Lift Support; Door Lift Support; Lift Support; Support Cylinder; Strut, End Gate Support
Position: Driver Side
Replaces: 22792139, 23289224
Fits the following Chevrolet Models:
Suburban | 2015-2020 | LS, LT, LTZ, Premier | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
Suburban 3500 HD | 2016-2019 | LS, LT | 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS
Tahoe | 2015-2020 | LS, LT, LTZ, PPV, Premier, SSV | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
Other Name: Strut, Rear Compartment Lid Or Tail Gate Counter Balance; Trunk Lid Lift Support; Door Lock Cylinder; Lift Support; Cylinder; Strut, Rear Hatch Window
Position: Rear
Fits the following Chevrolet Models:
Corvette | 2014-2019 | Grand Sport, Stingray, Z06 | 8 Cyl 6.2 L GAS
Q: How to replace the rear tailgate lift support on Chevrolet Tracker?
A: Start by using a wrench to remove the nut connecting the strut to the endgate panel. Next, remove the nut securing the strut to the endgate opening. Finally, extract the endgate strut from the vehicle. Secure the endgate strut to the endgate opening while placing it through the opening then tighten it with the nut by following the Fastener Notice in Cautions and Notices. The endgate strut needs to be attached to the endgate panel before tightening the nut to secure the installation. Secure endgate strut nuts to a torque of 15 Nm (11 lb ft).