Q: How to replace the rear side door window channel on Chevrolet Colorado?
A: Start by setting the rear side door window at its highest position while replacing the channel. Take off the rear door trim panel plus the rear inside Door Handle along with the rear door speaker and the water deflector. Start by unscrewing the bolt keeping the inner door panel to the run channel then lower the Window Channel from the top window frame before extracting the entire channel from the door. Insert the window run channel into the rear door and smoothly raise it inside the top window frame. Attach the bolt that keeps the rear door window run channel fixed to the door panel interior and secure it at 9 nm (80 lb in). Reconnect the rear door's water deflector, speaker, inside handle, and trim panel one by one.
Q: How to replace the rear door window channel on Chevrolet Impala?
A: The installation process for substituting the rear door window channel must begin with the application of masking tape to the door frame and applique to stop paint damage. Begin by removing the rear door trim panel while you also remove the rear door water deflector. First position the window to its lowest point then take out the window channel bolt for subsequent channel removal from the door. The window channel installation requires you to put it inside the door while using the window channel bolts to lock it into place until they reach 10 N.m tension (89 lb in torque). The installation procedure ends with a check for window functioning then mask tape removal from the frame and applique while reattaching the rear door water deflector as well as trim panel.
Q: How to replace the front side rear window channel on Chevrolet Malibu?
A: Begin procedures by removing the front door locking system module then disconnect the front door window rear channel from its holder. Install the front door window rear channel into its retaining clips and check that all locking tabs have caught before putting back the front door locking system module.