Q: How to replace the Trunk Lock Cylinder on Chevrolet Camaro?
A: To update the lift gate lock cylinder begin by opening your window panel and taking off the rear end finish panel. Afterward remove the seven rivets before pulling out the lock cylinder. During cylinder installation keep the tan indicator facing upward. Feed the lock cylinder shaft through the hole in the panel and lock support until you align the cylinder then place both right and left rivets. Reposition the rear end finish panel during the last step.
Q: How to replace the rear Trunk Lock Cylinder on Chevrolet Impala?
A: The first thing to do to replace the rear compartment lid lock cylinder on the impala is to take off the rear compartment lid applique. Afterward, peel out the 2 rivets that secure the lock cylinder to the rear compartment lid, then take away the lock cylinder and gasket. To install, line up the lock cylinder shaft with the rear compartment lid latch, and then put the lock cylinder and gasket over the holes in the lid, pressing them in until they sit flushed. Affix the lock cylinder and gasket to the rear compartment lid using 2 rivets, and then put the rear compartment lid applique back in place.
Q: How to replace the Trunk Lock Cylinder in the rear compartment lid on Chevrolet Malibu?
A: To replace the trunk/liftgate lock cylinder in the compartment lid at the rear, first, take out the rear compartment lid applique. Then, disconnect the rear compartment lid lock cable from the lock cylinder with a flat bladed tool. Drill out the rivets that hold the lock cylinder in place in the rear compartment lid, then dispose of the lock cylinder and gasket. For install, place the lock cylinder and gasket onto the rear compartment lid, press on the rivets and engage the rear compartment lid lock cable onto the lock cylinder until the retainer tabs are fully seated. Lastly, reinstall the rear compartment lid applique.