Q: How to replace the front door window motor in coupe and sedan on Chevrolet Camaro?
A: The first task for replacing Window Regulator motors in coupe and sedan front doors involves removing the Window Regulator itself. Create a drilling hole through the combination of Window Regulator sector gear and backplate before you install a locking bolt and nut to fix the sector gear securely in place. The procedure calls for drilling the rivets before you detach the regulator motor from the regulator. After attaching the regulator motor to the regulator , install the new rivets according to procedure. Reinstall the Window Regulator after you remove both the bolt and nut securing the sector gear.
Q: How to replace the rear side door window motor on Chevrolet Colorado?
A: One must take out the rear door Window Regulator before moving onto the replacement of the rear side door Window Motor. You must first detach the rear Window Motor from the bracket by removing its mounting bolts. After that detach the motor from the regulator. After attaching the rear Window Motor to the regulator install bolts which will keep the motor in position on the regulator bracket at 4.5 n.m (40 lb in). To complete the process install the rear door Window Regulator.
Q: How to Service and Repair the Front Door Window Motor on Chevrolet Malibu?
A: The first step to replace a front side door Window Regulator motor involves trimming the front door panels before proceeding. The second step includes removing the front door water deflector. Access the bolts (1, 2) by raising the window to its sufficient height then remove these bolts. Secure the window at its highest point through window tape. The electrical connector should be removed from the power Window Motor before pulling out the front door Window Regulator through the access hole found in the inner panel. Separate the power Window Motor bolts from their mounting position on the Window Regulator. Start the installation by fastening power Window Motor bolts to the regulator before tightening them to 6 nm (53 lb in). Install the Window Regulator and motor into the access opening after which attach the electrical connector to power Window Motor. The masking tape removal allows access to lower the window until the bolts (1) and (2) become visible to install. The bolts require tightening to 10 nm (89 lb in) during their installation. Secondly inspect the window for proper operation before replacing the front door water deflector along with the front door trim panel.