Other Name: Lock, Rear Compartment Lid Or Tail Gate Latch; Trunk Latch; Door Lock; Latch; Latch, Rear Compartment Lid Or Tail Gate Latch; Latch, Rear Compartment Lid Release Or Ajar
Other Name: Latch Assembly-Front Side Door; Door Lock Actuator Motor; Door Latch Assembly; Door Lock Actuator; Door Lock; Latch Assembly; Lock; Latch; Latch, Front Side Door; Latch, Door Lock
Position: Front Driver Side
Replaced by: 13546477
Fits the following Chevrolet Models:
Colorado | 2023 | LT, Trail Boss, WT, Z71, ZR2 | 4 Cyl 2.7 L GAS
Q: How to replace the front side door lock actuator on Chevrolet Impala?
A: The first step for replacing the front side Door Lock Actuator requires unfastening the front Door Lock. The first step requires removing the screws that connect the front Door Lock to the front Door Lock Actuator. Move on to remove the front door actuator from the front Door Lock. Position the front door actuator to its designated place on the front Door Lock before adhering to fastener precautions to safeguard the vehicle from damage. Screw in the front Door Lock to front door actuator screws until they reach 2 nm tightness (18 lb in). The replacement process ends with reinstallation of the front Door Lock.
Q: How to replace the rear door lock actuator on Chevrolet Malibu?
A: The procedure for replacing a rear Door Lock Actuator requires uninstalling the rear Door Lock followed by unfastening the screws securing the lock actuator until it becomes free. Place the new rear Door Lock Actuator on the rear Door Lock after freeing the actuator by following the service precautions regarding fastener notices. You must install the rear Door Lock Actuator screws to 2 n.m (18 lb in) torque level before replacing the rear Door Lock.
Q: How to replace the front door lock actuator on Chevrolet S10?
A: The process of replacing the front Door Lock Actuator requires beginning with door trim panel removal then proceeding to water deflector and Door Latch Assembly removal. The lock actuator requires removal of its 2 securing screws. After lifting and rotating the actuator gently you must disconnect the rubber Bumper from the latch before removing the actuator. Begin the installation by binding the rubber Bumper on the latch yet ensure the first gear tooth alignment between the actuator and latch components. Full engagement of the rubber Bumper becomes possible when you rotate the actuator toward the latch before positioning it at the top of the latch. Set the actuator in place by using the 2 screws to fasten it onto the latch while tightening them to 0.75 n.m (6 lb in). The last step involves reinstalling the latch onto the door and then putting back both the water deflector and the door trim panel.