Other Name: Actuator Kit, Door Lock; Trunk Lock Actuator Motor; Door Lock Actuator; Lock Actuator; Electric and Vacuum Door Locks; End Gate Electrical Actuator Kit.
Other Name: Actuator Kit, Door Lock; Door Lock Actuator; Lock Actuator; Actuator; Actuator Kit, Door Electric And Vacuum Locks; Actuator Kit, Door And End Gate Electrical
Other Name: Latch, Door Lock; Door Latch Assembly; Latch
Position: Driver Side
Replaces: 15757062, 15075234
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2002-2004 Chevrolet Avalanche 2500 | Base | 8 Cyl 8.1 L GAS
Chevrolet Avalanche 2500 Door Lock Actuator
Our website offers an extensive catalog of genuine Chevrolet Avalanche 2500 Door Lock Actuator at unbeatable prices. Every OEM Chevrolet Avalanche 2500 Door Lock Actuator comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Avalanche 2500 Door Lock Actuator Parts Questions & Experts Answers
Q: How to replace the front door lock actuator on Chevrolet Avalanche 2500?
A: Begin by raising the window glass followed by door trim panel and water deflector removal. The front Door Lock Actuator replacement requires you to separate the inside door lock rod from the handle retainer clip as well as the manual door lock rod from the door retainer clips. To disconnect the cylinder lock rod you need to remove the rubber plug that lets you release the outside handle rod retainer. The door lock mechanism needs its bolts removing before you can extract the actuator assembly from its mounting position. When applicable disconnect the electrical connector from the Door Lock Actuator and separate the control rods as an additional step. You should begin installation by connecting control rods to their assembly before you connect electrical connectors to the Door Lock Actuator if your vehicle has this feature. Install the Door Lock Actuator to its position on the door and attach the control rod to the outside handle. Then join the cylinder lock rod. Insert Door Lock Actuator mounting bolts into place while tightening them to 9 n.m torque (80 lb in). The door retainer clips accept the manual door lock while the inside Door Handle control rod connects to both the lock assembly and handle retainer clip. After installing the water deflector and door trim panel complete an inspection of all components in operation.