GM 15110647
Lock, Front Passenger Side

The process to replace the rear door latch (Cargo Door Upper) begins by removing the door trim panel then continuing with bolt removal that keeps the latch attached to the door. You should remove the latch while disconnecting the actuator cable assembly until you can take out the latch bolts and completely remove the latch. Begin by linking the actuator cable assembly to the latch after which you should install the bottom two bolts without tightening them. Expose the latch assembly by closing the door to enable self-adjustment and securely bolt these components to 9 N.m (80 lb in force). Open the door to position the upper bolt before tightening it to 9 N.m (80 lb in) and afterward reattach the door trim panel.

You start the liftgate lock actuator replacement by taking off upper and lower trim before disconnecting electrical connectors and removing cables. Unbolt the latch actuator then remove the unit from the liftgate before taking out the liftgarte lock cylinder. You should put in the liftgate lock cylinder first but then connect the actuator to the liftgate and put the bolts onto the actuator loosely. Adjust the actuator to its proper position by closing the liftgate glass while following the service precautions instructions on fasteners. Tighten each bolt within the actuator assembly to 9 n.m while connecting the cables according to their designated positions. After that connect all electrical wiring and place back the upper and lower trim panels.

Attach the actuator cable assembly to the latch.

The manual door lock rod.

Begin by removing the door trim panel.

Remove the liftgate lock cylinder.

Start by installing the control rods to the assembly and connecting the electrical connectors to the door lock actuator if equipped.

Connect the control rod to the outside door handle and then connect the cylinder lock rod.

Disconnect the electrical connector from the door lock actuator and remove the control rods as necessary.

Attach the control rods to the assembly and connect the electrical connectors to the door lock actuator if equipped.

Loosely assemble the bottom two bolts.

The cylinder lock rod.

If necessary, disconnect the electrical connector and then remove the actuator cable assembly from the latch.

Take out the bolts that secure the latch to the door and then remove the latch itself.

Install the latch to the door and tighten the bolts to 9 N.m (80 lb in).

Install the door lock actuator to the door, connect the outside door handle control rod, and the cylinder lock rod.

Connect the latch rod to the latch, ensuring to adhere to the Fastener Notice in Service Precautions.

Connect the outside door handle control rod and the cylinder lock rod.

Install the latch retaining bolts.

Remove the bolts that secure the latch to the door.

Tighten these bolts to 9 N.m (80 lb in).

Disconnect the inside door lock rod.

Tighten it to 9 N.m (80 lb in).

Connect the manual door lock to the door retainer clips.

Connect the latch rod to the latch, ensuring to adhere to the Fastener Notice in Service Precautions.

Disconnect the electrical connector from the door lock actuator.

Reinstall the latch retaining bolts and the door trim panel.

The control rod for the inside door handle.

Disconnect the cylinder lock rod.

Install the bolts that secure the latch assembly to the door, tightening them to 25 N.m (18 lb ft).

Begin by installing the control rods to the assembly.

Disconnect the manual door lock rod.

Begin by removing the door trim panel.

Open the door and install the upper bolt.

First, remove the door trim panel.

Remove the latch retaining bolts.

The manual door lock rod.

Remove the bolts that secure the latch to the door.

Attach the control rods to the assembly and connect the electrical connectors to the door lock actuator if equipped.

Remove the door trim panel and the water deflector.

Install the bolts that retain the door lock actuator to the door, tightening the screws to 9 N.m (80 lb in).

The inside door lock rod.