Other Name: Actuator Kit, Door Lock; Door Lock Actuator; Lock Actuator; Actuator; Actuator Kit, Door Electric And Vacuum Locks; Actuator Kit, Door And End Gate Electrical
Other Name: Actuator Kit, Door Lock; Trunk Lock Actuator Motor; Door Lock Actuator; Lock Actuator; Electric and Vacuum Door Locks; End Gate Electrical Actuator Kit.
Other Name: Latch Assembly-Rear Side Door; Door Latch Assembly; Door Lock; Latch; Latch, Door Lock
Position: Rear Passenger Side
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2001-2004 Chevrolet Silverado 2500 | Base, LS, LT, WT | 8 Cyl 6.0 L BI-FUEL, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L GAS
| Page 1 of 2 |Next >
1-20 of 23 Results
Chevrolet Silverado 2500 Door Lock Actuator
Our website offers an extensive catalog of genuine Chevrolet Silverado 2500 Door Lock Actuator at unbeatable prices. Every OEM Chevrolet Silverado 2500 Door Lock Actuator comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Silverado 2500 Door Lock Actuator Parts Questions & Experts Answers
Q: How to replace the power door lock actuator in the front door on Chevrolet Silverado 2500?
A: One must lift the window glass before taking out the door trim panel and water deflector to replace the power door lock actuator in the front door. Before moving forward the door mechanic should take out the inside door lock rod from its connection to both the handle retainer clip and manual door lock rod from its connection to door retainer clips. The removal of the rubber plug allows you to disconnect both the outside handle rod retainer from the cylinder lock rod. To replace the door lock actuator you should remove its mounting bolts from the door while pulling out all components made up of actuator and control rods. The electrical connector of the door lock actuator and control rods need to be removed when required. You should start the installation process by putting the control rods on the assembly before connecting the electrical connectors to the door lock actuator when it has them. Install the door lock actuator into the door opening while connecting outside door handle control rod and cylinder lock rod. Secure the door lock actuator bolts in place on the door using 9 N.m torque (80 lb in). You should connect three components: the manual door lock should link to the door retainer clips and both the inside door handle control rod must connect to the lock assembly along with the inside door lock rod which must link to the handle retainer clip. You should install the water deflector followed by the door trim panel before performing an inspection of all affected components.