Begin by taking off the upper and lower trim panels, and then disconnect the power connectors before taking off the cables from the actuator assembly. Then, take out the bolts that fasten the latch actuator, take off the actuator, and after that, the liftgate lock cylinder. At installation, start with fitting the liftgate lock cylinder, then fixed the actuator onto the liftgate and only put the bolts into the latch actuator loosely. In order to adjust the actuator, first close the liftgate glass and refer to the fastener notice listed in service precautions. After the actuator has been adjusted, reinstall the cables to its assembly and tighten the bolts to 9 n.m (80 lb in). Reattach all electrical connectors and at the end, put the upper and lower trim panels back in place.