GM 15034723
Deflector, Front

Begin replacement of the end gate utility vehicle bumper by taking off its lower side bolt. Twist the side bumper and spacer away from the lower bolt hole by loosening the top side bolt. Then put the lower bolt back in and tighten it to lock the backing plate in place. Unscrew the upper side bumper bolt before taking off both the spacer and the side bumper from their positions. Start the procedure by connecting the side bumper first then adding the spacer (if added). Later install the upper side bumper bolt. Turn the lower side bumper bolt to place its threaded end into position before taking it out. Turn both the side bumper and spacer parts (when present) to place the threaded hole of the backing plate in the correct position. Fit the lower side bumper bolt into place before tightening it to 22 N.m (16 lb ft).

Begin repair of the end gate (utility) bumper by taking out one lower side bumper bolt independently to stop the backing plate from entering the body. First remove the upper side bumper bolt which enables side bumper and spacer rotation (if equipped) and then reposition the lower side bumper bolt for backing plate installation. Once you finish with the upper side bumper bolt you should also remove the spacer (if equipped) and the side bumper. Start by attaching the side bumper after the spacer if included then move onto the upper side bumper bolt installation. After rotating the lower side bumper bolt to line up its threaded hole you should remove and reposition the side bumper and spacer (when present) to fit into the threaded hole of the backing plate. After aligning the threaded lower side bumper bolt hole with the backing plate, fasten it with a torque of 22 N.m (16 lb ft).

The first step to replace front Bumper fascia (Xtreme) is to elevate the vehicle. First disconnect the electrical connector from the foglamps before removing both push-pins which connect the fascia to the impact bar as well as screws which secure the fascia to the fascia support. Detach the fascia from its mount on the impact bar retainers while removing it from the complete vehicle. The installation of the front fascia should begin by placing it on top of the vehicle while closely following the fastener instructions. Install screws on the fascia to secure them to impact bar retainers while maintaining a torque level of 1.9 n.m (17 lb in). The push-pins can be reinstalled to connect fascia to impact bar followed by connecting the electrical connector to foglamps before manipulating the vehicle descent.