GM 94857148
Bumper Cover

The process of replacing the rear bumper fascia starts with opening the rear compartment lid then disconnecting the left rear end trim finish panel and right rear end trim finish panel and removing the rear compartment sill trim plate. You must remove the license plate lamps before starting to detach them from the rear bumper fascia. The installation requires removal of 4 center nuts and 2 bottom plastic retainers and the 3 nuts located at each side. Pull the rear bumper fascia towards the rear and take it out from the vehicle. Secure the rear bumper fascia by attaching it to the vehicle using the 3 side-mounted nuts along with bottom-bolted 2 plastic retainers and center-mounted 4 nuts then tighten the nuts to 20 N.m torque (15 lb ft). Reinstall the plate lamps followed by left and right end finish panel and rear sill trim plate reattachment before closing the compartment.

The process of replacing a rear bumper fascia starts with opening the rear compartment lid before removing the left rear end trim finish panel and right rear end trim finish panel as well as the rear compartment sill trim plate. You must remove the license plate lamps from the rear fascia of the bumper. First remove all 4 nuts fastening the central section then disconnect both bottom plastic retainers and the 3 nuts from each side. Pull the rear bumper fascia backward before taking it off from the vehicle. The installation process starts with attaching the rear bumper fascia to the vehicle by tightening the 3 nuts located at the sides as well as the 2 plastic retainers at the bottom and 4 nuts at the center to 20 N.m (15 lb ft). Reinstall the license plate lamps before installing left and right rear end trim finish panels and rear compartment sill trim plate to finish the task by closing the rear compartment.

Attach the rear bumper fascia to the vehicle, securing it with the 3 nuts on each side, the 2 plastic retainers at the bottom, and the 4 nuts at the center, tightening the nuts to 20 N.m (15 lb ft).