OEM 2000 Chevrolet Prizm Bumper

2000 Chevrolet Prizm Bumper Parts Questions & Experts Answers

• Q: How to replace the rear bumper fascia on 2000 Chevrolet Prizm?

  A: The process starts with opening the rear compartment lid and uninstalling the left rear end trim finish panel together with right rear end trim finish panel and rear compartment sill trim plate. Reshape the license plate lamps by detaching them from the rear bumper facia. Begin by removing the 4 center nuts that fasten the unit as well as the two bottom plastic retainers and the three side nuts from each segment. Pull the rear bumper fascia towards the back before removing it from the vehicle. Apply the rear bumper fascia to the vehicle by using 3 nuts per side, 2 plastic retainers at the bottom and 4 nuts at the center while tightening nuts to 20 N.m (15 lb ft). Begin installation by first installing the license plate lamps and then install the left rear end trim finish panel, right rear end trim finish panel and rear compartment sill trim plate. Close the rear compartment lid afterward.