GM 25737019
Emblem, Front

Apply tape to cover the surface before uninstalling the emblem/nameplate. Heat up the front emblem/nameplate with J 25070 Heat Gun (J 25070) for 30 seconds while making simple circular motions. Gently take out the emblem/nameplate by sliding a plastic flat blade across its edge. Clean the surface thoroughly before installing a new emblem/nameplate according to these steps: use the 3M(TM) Scotch Brite molding adhesive remover disk (3M(TM) P/N 07502) or an equivalent to remove old adhesive from body parts; wipe plastic parts with a VMP naphtha solution or 50/50 isopropyl alcohol mix on a lint-free cloth. You need to work on a clean and dry space where you can put the emblem so its hole touches the fender surface. Heat the mounting surface to 27-41°C (80-105°F) by using J 25070 Heat Gun (J 25070). Place the emblem/nameplate under heat to get a temperature range of 29-32°C (85-90°F) while keeping it away from the adhesive side. Apply the raised edge of the emblem/nameplate against its mounting surface and stick it firmly in place by pressing down evenly across the entire surface. Finally, remove the protective tape.

For body panels, use a 3M(TM) Scotch Brite molding adhesive remover disk or an equivalent; for plastic panels, use a lint-free cloth with Varnish Makers and Painters naphtha or a 50/50 mixture of isopropyl alcohol and water.

For body panels, use a 3M(TM) Scotch Brite molding adhesive remover disk or an equivalent; for plastic panels, use a lint-free cloth with Varnish Makers and Painters naphtha or a 50/50 mixture of isopropyl alcohol and water.