GM 88959448
Body Side Molding

Start by removing the front door outer belt sealing strip before you can replace the front side door opening frame garnish molding. Begin by peeling front door frame molding from the pillar while applying heat to the applique until removal is possible. Dismantle all painted surfaces by rinsing away adhesive residue with a silicone, wax and grease remover. Start by cleaning the surface with a silicone, wax, grease remover followed by application of a 50-50 isopropyl alcohol water mixture then strike the panel with a clean cloth when solvents are still wet before allowing the surface to dry. Placing the front door frame molding facing downward enables access to remove the backing material while you align its opening with the hole at the beltline pillar. The top edge must stay parallel to the door's perimeter. A foaming-type window solution free of ammonia-based wetting substances should provide positioning ease when installing the molding. After setting the molding on the pillar begin from the middle to position it through squeegeeing and maintain additional wetting solution when needed for easier setup. Solutions with soap water applied to the molding's top surface will protect it from damage when using a squeegee tool. Heat gun application for a short time on the molding's top corners along with vertical edges should precede premask removal. Prepare the molding to arch around the pillar's hem flange and front section while heating it until the bonding stays strong. You should complete installation of the front door outer belt sealing strip as your final step.