OEM 2000 Cadillac Eldorado Fuel Injector

2000 Cadillac Eldorado Fuel Injector Parts Questions & Experts Answers

• Q: What tools are required to service and repair the fuel injector on 2000 Cadillac Eldorado?

  A: The required tools for Fuel Injector servicing and repair include fuel pressure gauge (J 34730) and Fuel Injector removal tool (J 43013). Initiate operations by reducing fuel pressure from the system. Detach the Fuel Injector electrical connector from its installation position on the Fuel Injector unit. Better access requires a user to detach the Fuel Rail from the position where it connects to the Intake Manifold. The Fuel Injector removal tool (J 43013) lets you pull up fuel injectors from the engine Intake Manifold after getting rid of the Fuel Rail bolts. Keep the assembled Fuel Rail in a clean safe area which should remain at minimum distance from heat sources. Start by lifting out the Fuel Rail altogether followed by detached adjacent injector components leading to better work area access. The injector retainer clip needs to be spread to free the injector from the Fuel Rail for removing the Fuel Injector assembly. Extract both upper o-ring and lower o-ring from the Fuel Injector before removing and discarding the old seals. The new upper and lower o-rings require cleaning engine oil for lubrication before getting installed onto the Fuel Injector. Use the Fuel Rail assembly to push forward into the Intake Manifold position until all injectors seat properly before opening the injector retainer clip for installation of the Fuel Injector onto the rail. Fasten the Fuel Rail assembly bolts while tightening them with 10 n.m (88 lb in). Install the Fuel Rail onto the manifold section then reconnect the electrical wiring of the Fuel Injector. Start by adding fuel into the tank and finally secure the fuel filler cap with proper torque. Turn on the ignition for two seconds followed by ten seconds of turning it off before turning it on once more to detect any fuel leakages. The final step is to fit and secure the Fuel Injector sight shield by torquing its sight shield nuts to 3 n.m (27 lb in).