OEM 2000 Chevrolet Suburban 1500 Fuse Box

2000 Chevrolet Suburban 1500 Fuse Box Parts and Q&A

• Q: How to Replace a Fuse Box in the IP Wiring Harness Junction Block on 2000 Chevrolet Suburban 1500?

  A: The procedure starts with disconnecting the negative Battery Cable(s). Next remove the right side end panel before proceeding. Disconnect all wiring connectors attached to the front part of ip junction block before unclipping the harness from its fastener. To remove the ip wiring harness junction block squeeze its two retaining clips and pull it out toward the rear. The lower ip light bulb requires counterclockwise twisting and then rearward removal. The ip wiring harness junction block needs to be slipped through a hole in the ip while all wiring connectors must be detached from its rear section before extracting it from the vehicle. Insert every wire connector to the back of the ip wiring harness junction block then guide it through the ip hole. Connect the lower ip light bulb through clock-wise bulb socket rotation combined with bulb pushing in before doing the same for the ip wiring harness junction block connection to the ip through clip pressure application leading to a sealed connection. To complete the installation, install the right side end panel then reattach the negative Battery Cable(s) while connecting wiring connector(s) to the front of the ip wiring harness junction block.