How to Service and Repair a Steering Angle Sensor on 2000 Chevrolet Tahoe?

Lock the steering wheel with wheels straight, disconnect negative battery cable and disable SIR. Remove upper-to-lower shaft nut/bolt, slide lower shaft down. Disconnect position sensor connector and pull aside. Extract sensor and bearing, separate components. Reinstall sensor, bearing, align notches, seat fully, reconnect connector, reinstall bolt/nut, reconnect battery and enable SIR.

OEM 2000 Chevrolet Tahoe Steering Angle Sensor

Steering Column Angle Position Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Steering Angle Sensor found

View related parts
2000 Chevrolet Tahoe Speed Sensor Part Number: 26064468
$72.07 MSRP: $128.70
You Save: $56.63 (44%)
Product Specifications
- Other Name: Sensor, Steering Column; Steering Wheel Speed Sensor; Steering Angle Sensor; Position Sensor; Sensor
- Item Weight: 0.40 Pounds
- Item Dimensions: 5.1 x 4.1 x 4.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 26064468
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2000 Chevrolet Tahoe Submodels:
- Base, Limited, LS, LT, Z71 | 8 Cyl 5.7 L GAS, 8 Cyl 6.5 L DIESEL

2000 Chevrolet Tahoe Steering Angle Sensor

With a comprehensive array of OEM 2000 Chevrolet Tahoe Steering Angle Sensor, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2000 Chevrolet Tahoe Steering Angle Sensor are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2000 Chevrolet Tahoe Steering Angle Sensor Parts and Q&A

Q: How to Service and Repair a Steering Angle Sensor on 2000 Chevrolet Tahoe?
A: Lock the steering wheel with wheels straight, disconnect negative battery cable and disable SIR. Remove upper-to-lower shaft nut/bolt, slide lower shaft down. Disconnect position sensor connector and pull aside. Extract sensor and bearing, separate components. Reinstall sensor, bearing, align notches, seat fully, reconnect connector, reinstall bolt/nut, reconnect battery and enable SIR.