OEM 2004 Chevrolet Corvette ABS Control Module

2004 Chevrolet Corvette Parts Questions & Experts Answers

• Q: How to replace the ABS Control Module on 2004 Chevrolet Corvette?

  A: The first step of ABS Control Module replacement requires turning off the ignition while breaking the ABS Control Module harness connection. The ABS Control Module/BPMV requires lifting from the bracket by removing two insulator nuts in order to align both the insulator bolt and the ABS Control Module. First remove the insulator mounting bolt from the ABS Control Module then follow with the four ABS Control Module to BPMV bolts to ease separation of ABS Control Module from BPMV. The seal can be reused if not marked by damage while being carefully removed. Apply alcohol using a clean rag to clean the BPMV seal surface before putting the seal in place only if it remains undamaged and uncut. Begin ABS Control Module mounting operations by installing the device to the BPMV while tightening four mounting bolts according to the following sequence: 3 Nm (27 inch lbs.) first pass and 6 Nm (53 inch lbs.) second pass. The installation requires a fresh insulator nut when the original one has been removed. Attach and tighten the front ABS Control Module insulator mounting bolt to 14 Nm (10 ft. lbs.). Set the ABS Control Module/BPMV into its bracket then install two insulator nuts which should be fastened to 10 Nm (89 inch lbs.). Use the ABS Control Module harness connector by ensuring both mechanics are openly visible through the lever before performing the closure. Start the diagnostic system check by putting the ignition switch to ON with engine remaining inactive.