OEM 2005 GMC Envoy Antenna Cable

2005 GMC Envoy Antenna Cable Parts and Q&A

• Q: How to Replace an Antenna Cable on 2005 GMC Envoy?

  A: To replace Antenna Cable, open the instrument panel (I/P) compartment fully and disconnect the radio Antenna Cable from the radio extension cable. Take out the lower rear part of the wheelhouse panel, or reach behind it to remove Antenna Cable and gromomet assembly from the cowl hole. Pass the radio Antenna Cable assembly end through the opening at the cowl and slide out the Antenna mast. Lift the hood, remove the radio Antenna Cable assembly retaining screws and push the Antenna Cable and grommet assembly through the fender opening and remove the assembly from the vehicle. For installation, start by installing the radio Antenna Cable assembly back into a vehicle, and route the Antenna appliance and grommet assembly through a fender opening. Screw up the retaining screws on the radio Antenna Cable assembly to 2.8 n.m (25 lb in). Shut the hood down close the mast Antenna and squeeze recovery in behind the wheelhouse panel to get the end of the radio Antenna Cable assembly through the cowl opening. Install the Antenna Cable grommet assembly to cowl opening, reconnect wheelhouse panel, plug radio Antenna Cable into radio extension cable, lastly, close i/p compartment.