OEM 2007 Buick Lucerne Antenna Cable

2007 Buick Lucerne Parts Questions & Experts Answers

• Q: How to replace the digital radio antenna cable on 2007 Buick Lucerne?

  A: To replace the digital radio Antenna Cable, start by removing the upper rear quarter trim panel and the rear assist handles to not bend the headliner too much damaging it. Lower the rear of the headliner; unsolder the Antenna Cable from the clips (2,3) and remove the connection of the Antenna Cable from above the am/fm Antenna module, removing foam tape from this connection. Next, remove the connectors from the radio Antenna to allow you to tie a bit of wire or string to the end of the Antenna wire. Pull off the connection of the Antenna Cable from the digital receiver and remove the left rear compartment trim panel. Take the Antenna Cable out of the clips and the rear harness, and pull it through to the rear compartment, and take the wire or string out of the Antenna Cable before taking the cable off from the vehicle. To put in place, tie the wire or string to the new cable and gently pull the Antenna Cable over the rear shelf into the passenger compartment, then take off the wire or string. Connect the Antenna Cable connection to the digital receiver and clip the Antenna Cable to the hold-down clips in the rear compartment. Replace the trim panel in the left rear compartment and attach the Antenna connectors to the digital radio Antenna, and wrap a connector with foam tape. Revert the Antenna Cable hook up above the am/fm Antenna module and attach the Antenna Cable to the locating clips on the roof, the third pillar, and to the headliner in the line with the roof panel finally ante-rail the back side handles, and the higher rear quarter trim panel.