OEM 2010 Chevrolet HHR Control Arm Bushing

2010 Chevrolet HHR Control Arm Bushing Parts Questions & Experts Answers

• Q: How to replace the control arm bushing on 2010 Chevrolet HHR?

  A: Vehicle support and elevation are necessary before commencing bushing replacement work on the control arm. Use body bolts to hold up the vehicle before removing the lower shock bolts from the rear axle. Then reinstall the lower shock bolts temporarily as axle support. Keep a mental note of how deep the old bushing went inside as well as its placement direction. The j 44570 bushing remover/installer kit functions with j 44570-1, j-44570-4, j 44570-3, and j 44570-1 along with a hammer to extract the bushing from the rear axle. The correct orientation for axle bushings must be established before their installation begins. The rear axles must receive new bushings where the rubber end faces the inside while the bushing's largest notch aligns with the wheel hub center. Install the rear axle bushing using equipment that includes j 44570-1, j-44570-4 , j 44570-3 , and j 44570-2 from j 44570 bushing remover/installer kit. Block the axle bracket to body bolts using a finger until brackets reach a flush position before securing all body-mounted and lower Shock Absorber mounts firmly to the rear axle. After installing the rear wheels, remove the supports to lower the vehicle into position.