OEM Chevrolet Avalanche 1500 Starter

Chevrolet Avalanche 1500 Starter Parts Questions & Experts Answers

• Starter
  89018123
  Q: How to replace the starter motor on Chevrolet Avalanche 1500?

  A: A vehicle replacement procedure for Starter motors begins with disconnecting the negative Battery Cable followed by vehicles suspension. The first step is to remove the transmission cover bolt while those with four wheel drive (4WD) should untighten the front axle mounting bracket nuts to place the front axle mounting bracket bolt in correct alignment with the support bushing without removing the bolt. Start by taking off the Starter bolts along with removing the oil level sensor electrical connector. Migrate the Starter at least 5.0 cm forward beyond the transmission while removing the Starter lead nut followed by the Starter lead as well as positive cable nut and positive cable. The Starter should be positioned on a workbench while you need to remove both the transmission cover snap and any Starter heat shield protection. Start by attaching the Starter heat shield to its place and then secure the transmission cover onto the Starter if required. The positive cable installation requires connecting it to the starting component while applying the positive cable nut and tightening it to 9 n.m (80 lb in). Connect the Starter lead and fasten the Starter lead nut tight at 3.4 n.m (30 lb in). Position the Starter into place before installing Starter bolts which should be tightened to 50 n.m (37 lb ft). The front axle mounting bracket nuts require tightening to 95 n.m (70 lb ft) after ensuring the bolt for the front axle mounting bracket bolt is fully engaged and 4wd systems are present. End by installing the transmission cover bolt which requires 9 n.m torque (80 lb in torque) before lowering the vehicle and restoring the negative Battery Cable.