How to replace the fuel pressure sensor on Chevrolet Tahoe?

The first step to replacing the Fuel Pressure Sensor involves removal of the front propeller shaft if the vehicle operates with 4 wheel drive (4WD). You must disconnect the chassis wiring harness electrical connector which serves the Fuel Pressure Sensor . A shop towel should be used to soak up fuel leakage while removing the Fuel Pressure Sensor from its fuel line position before discarding the Fuel Pressure Sensor o-ring seal. Start by applying clean engine oil to the new o-ring seal of the Fuel Pressure Sensor before installing it onto the fuel line fitting. Place the shop towel around the sensor fitting of the fuel pressure line to prevent fuel from leaking. Follow these steps to attach the Fuel Pressure Sensor onto the fuel line by tightening it to 15 nm (11 lb ft). Install the Fuel Pressure Sensor by connecting its chassis wiring harness electrical connector and then lower the vehicle. To detect leaks in the system turn the ignition switch on with the engine power off for 2 seconds after which you must turn the ignition switch off for 10 seconds followed again by turning the ignition switch on with the engine power off while checking for fuel leakage. Front propeller shaft installation should be performed only if the vehicle contains 4wd functionality.

OEM Chevrolet Tahoe Fuel Pressure Sensor

Fuel Tank Pressure Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

7 Fuel Pressure Sensors found

View related parts
Chevrolet Tahoe Fuel Pressure Regulator, Passenger Side Part Number: 16238399
$54.17 MSRP: $101.06
You Save: $46.89 (47%)
ADD TO CART
Product Specifications
- Other Name: Sensor, Fuel Tank Pressure; Fuel Tank Pressure Sensor; Fuel Pressure Sensor; Pressure Regulator; Sensor, Early Fuel Evaporation; Fuel Gauge Sending Unit; Tank Pressure Sensor
- Position: Passenger Side
- Replaces: 12206740, 16217059, 16257276, 22678829, 09377680, 12219388, 16196060, 9377680
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2007 Chevrolet Tahoe | LS, LT, LTZ | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
View related parts
Chevrolet Tahoe Pressure Sensor, Passenger Side Part Number: 13502903
$48.74 MSRP: $100.17
You Save: $51.43 (52%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor Kit, Fuel Tank Meter/Pump; Fuel Tank Pressure Sensor; Level Sensor; Tank Pressure Sensor; Sensor; Sensor, Early Fuel Evaporation; Sensor, Fuel Tank Meter/Pump
- Position: Passenger Side
- Replaces: 13502510
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2008-2023 Chevrolet Tahoe | Commercial, High Country, Hybrid, LS, LT, LTZ, PPV, Premier, RST, SSV, Z71 | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
View related parts
Chevrolet Tahoe Pressure Sensor Part Number: 12673824
$65.33 MSRP: $132.70
You Save: $67.37 (51%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor Assembly-Fuel Injection Fuel Rail Fuel Pressure; Fuel Tank Pressure Sensor; Fuel Pressure Sensor; Sensor, Computer Control Sensors
- Replaces: 12623130
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2015-2016 Chevrolet Tahoe | LS, LT, LTZ, PPV, SSV | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
View related parts
Chevrolet Tahoe Pressure Sensor Part Number: 12247409
$45.23 MSRP: $92.95
You Save: $47.72 (52%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor Kit, Fuel Tank Meter/Pump; Fuel Tank Pressure Sensor; Fuel Pressure Sensor; Tank Pressure Sensor; Sensor, Fuel Tank Meter/Pump
- Replaces: 88965447
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2007-2008 Chevrolet Tahoe | LS, LT, LTZ | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.2 L GAS
View related parts
Chevrolet Tahoe Pressure Sensor Part Number: 12708493
$22.92 MSRP: $43.04
You Save: $20.12 (47%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor Assembly-Fuel Injection; Fuel Rail Pressure Sensor; Fuel Tank Pressure Sensor; Sensor, Computer Control Sensors
- Replaces: 12684286, 12664124
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2017-2022 Chevrolet Tahoe | Commercial, High Country, LS, LT, PPV, Premier, RST, SSV, Z71 | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
View related parts
Chevrolet Tahoe Water Sensor Part Number: 12375515
$127.49 MSRP: $239.42
You Save: $111.93 (47%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor, Fuel Tank Meter/Pump
- Replaces: 12511965
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1995-1999 Chevrolet Tahoe | Base, LS, LT | 8 Cyl 5.7 L GAS, 8 Cyl 6.5 L DIESEL
View related parts
Chevrolet Tahoe Pressure Sensor Part Number: 55490628
$67.46 MSRP: $120.46
You Save: $53.00 (44%)
Product Specifications
- Other Name: Sensor Assembly-High Pressure Diesel Fuel; Fuel Tank Pressure Sensor; Fuel Pressure Sensor; Sensor, Fuel Tank Meter/Pump
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2021-2022 Chevrolet Tahoe | High Country, LS, LT, Premier, RST | 6 Cyl 3.0 L DIESEL

Chevrolet Tahoe Fuel Pressure Sensor

Want to cut long-term maintenance and repair costs? Choose OEM Fuel Pressure Sensor. Those parts deliver top durability you can trust. On our site, you'll find a huge catalog of genuine Chevrolet Tahoe parts. Prices are unbeatable, so you can keep more in your pocket. Every OEM Chevrolet Tahoe Fuel Pressure Sensor includes a manufacturer's warranty. You can also get an easy return policy that keeps buying risk free. Fast delivery, get your car on the road quickly. It's simple to search, compare, and order. Stop guessing about quality or fit. Order today and save with parts that last.

Chevrolet Tahoe's Fuel Pressure Sensor commonly referred to as the fuel tank pressure sensor assists in determining or checking fuel pressure in the tank as well as in the rail. Thus, transferring this information to the internal computer of the vehicle, the sensor allows for correct tuning of the engine's operation. There are various Tahoe car models, but fuel pressure sensors vary in design while having the basic function of keeping the engine efficient. Some of the symptoms of a bad sensor are difficult starting, poor fuel mileage, and bad running and a check engine light is sometimes a sign of a bad sensor. Fuel pressure sensor has considered relevance in the performance of the engine, and therefore, requires proper maintenance for its functionality.

Chevrolet Tahoe Fuel Pressure Sensor Parts Questions & Experts Answers

Pressure Sensor, Passenger Side
13502903
Q: How to replace the fuel pressure sensor on Chevrolet Tahoe?
A:
The first step to replacing the Fuel Pressure Sensor involves removal of the front propeller shaft if the vehicle operates with 4 wheel drive (4WD). You must disconnect the chassis wiring harness electrical connector which serves the Fuel Pressure Sensor . A shop towel should be used to soak up fuel leakage while removing the Fuel Pressure Sensor from its fuel line position before discarding the Fuel Pressure Sensor o-ring seal. Start by applying clean engine oil to the new o-ring seal of the Fuel Pressure Sensor before installing it onto the fuel line fitting. Place the shop towel around the sensor fitting of the fuel pressure line to prevent fuel from leaking. Follow these steps to attach the Fuel Pressure Sensor onto the fuel line by tightening it to 15 nm (11 lb ft). Install the Fuel Pressure Sensor by connecting its chassis wiring harness electrical connector and then lower the vehicle. To detect leaks in the system turn the ignition switch on with the engine power off for 2 seconds after which you must turn the ignition switch off for 10 seconds followed again by turning the ignition switch on with the engine power off while checking for fuel leakage. Front propeller shaft installation should be performed only if the vehicle contains 4wd functionality.